{"id":392,"date":"2021-03-26T22:11:25","date_gmt":"2021-03-27T03:11:25","guid":{"rendered":"https:\/\/startup.twistedjute.com\/?p=392"},"modified":"2021-04-05T15:59:55","modified_gmt":"2021-04-05T20:59:55","slug":"a-little-more-electrical-work","status":"publish","type":"post","link":"https:\/\/startup.twistedjute.com\/?p=392","title":{"rendered":"A Little More Electrical Work"},"content":{"rendered":"\n

So the main electrical power connection for the rope machine were mounted to a piece of sheet metal under the control panel. There wasn’t any effort made to prevent electrical shock or short circuit such as a proper electrical enclosure. So I purchased an 8″ x 8″ x 4″ electrical junction box to put the 220v breaker and relay inside of. <\/p>\n\n\n\n

\"\"<\/figure>\n\n\n\n

I modified the box and added a stand-off so the breaker switch could be flipped without taking the cover off. Since I had to disconnect the wires so I could route them into to box I decided to use properly color coded wire and run the ground wires to the .other controller. The factory just used red wire for everything and didn’t provide for a ground wire…<\/p>\n\n\n\n

Here are some before and after photos.<\/p>\n\n\n

\r\n\"\"\r\n<\/div><\/a>\n<\/div>\n <\/div><\/figure>\n
\r\n\"\"\r\n<\/div><\/a>\n<\/div>\n <\/div><\/figure>\n
\r\n\"\"\r\n<\/div><\/a>\n<\/div>\n <\/div><\/figure>\n
\r\n\"\"\r\n<\/div><\/a>\n<\/div>\n <\/div><\/figure>\n<\/div>\n